Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. And see here for current known issues.
Please how can I secure my wireless network with the following running config:
no aaa new-model
dot11 ssid ************
no ip address
speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
Thank you all!
Go to Solution.
What kind of security do you want to use? WPA-PSK with AES? If so, perform the following config:
dot11 ssid *******
authentication key-management wpa
wpa-psk ascii [password]
encryption mode ciphers aes-ccm
Try that and see if it works. Hopefully it does!
It works fine.
Meanwhile I have posted another question about DHCP configuration on WAP