Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Upgrade BootLoader on Cisco WLC 2504

      Hi I using WLC2504 with the last Software image     

Manufacturer's Name.............................. Cisco Systems Inc.

Product Name..................................... Cisco Controller

Product Version.................................. 7.5.102.0

Bootloader Version............................... 1.0.16

Field Recovery Image Version..................... 1.0.0

Firmware Version................................. PIC 16.0

Build Type....................................... DATA + WPS

System Name...................................... WLC-2504

System Stats Realtime Interval................... 5

System Stats Normal Interval..................... 180

Configured Country............................... US  - United States

Operating Environment............................ Commercial (0 to 40 C)

Internal Temp Alarm Limits....................... 0 to 65 C

Internal Temperature............................. +28 C

External Temperature............................. +32 C

Fan Status....................................... 4300 rpm

State of 802.11b Network......................... Enabled

State of 802.11a Network......................... Enabled

Number of WLANs.................................. 2

Number of Active Clients......................... 46

Maximum number of APs supported.................. 15

When I tried enable Application Visibility under WLANs->QoS

I received message that i need to upgrade  Bootloader to 1.0.18 version.

Does it mean I need to upload Field Upgrade Software-1.8.0.0 (AIR-CT2500-K9-1-8-0-0-FUS.aes) to my WLC?

EDITED:

I believe I found it

http://www.cisco.com/en/US/docs/wireless/controller/release/notes/crn75.html

If you are using a Cisco 2500 Series controller and you intend to use the Application Visibility and Control (AVC) and NetFlow protocol features, you must install Wireless LAN Controller Field Upgrade Software for Release 1.8.0.0-FUS. This is not required if you are using other controller hardware models. For more information, see

http://www.cisco.com/en/US/docs/wireless/controller/release/notes/fus_1_8_0_0.html

Everyone's tags (2)
1 REPLY
Hall of Fame Super Gold

Upgrade BootLoader on Cisco WLC 2504

It is strongly recommended to upgrade the FUS once you go to 7.4.X and above.

4014
Views
0
Helpful
1
Replies