I'm on version 4.0.219. It is working well but there is feature or 2 in 5.1 that I wan to implement but I remember when I upgraded to this version it was difficult the first time and it has been over a year.
Should I wait until a slack time and do I have to do incremental upgrades to get to 5.1 first?
I'm hoping someone will tell me to just jump right in.
Bo is right.... before you upgrade, you should really look at how you will proceed. Hopefully you can move all your ap's to one controller and then upgrade the other. This way you can make sure the ap's will upgrade correctly. I have seen issues during an upgrade where you still have ap's associated to the controller during the process. Depending on how many a['s, you can sort of estimate the length of time it will take you to upgrade all your ap's.
I have 2 controllers in 2 buildings, actually they are 20 miles apart and a 2 subnets but all part of the same Active Directory, but I have the dangest time keeping a couple of AP's from crossing over. I saw the response to my question on this except it needs version 5.1 to make it happen.
Thanks for this info. I do have some 1010's. This info probably saved me hours of trying to track something down. I'm on 4.0 and we don't do phones or anything like that on the wireless. We don't even do authentication as the signal stays pretty much just inside the building.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...