Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Upgrade of AP 1231 to lwapp, no join

Hello,

I know there are quite a few posts on this, however I have read many of them and also read over troubleshooting docs. I Upgraded ap 1231 to lwapp with upgrade tool, now it will not join WLC 2106.

However upgraded 1242 ap joined with no problems, same process.

Error messages on the controller are:

Jul 10 14:38:54.222: %LWAPP-3-RADIUS_ERR: spam_radius.c:138 Could not send join reply, AP authorization failed; AP:00:0f:23:21:67:7a

Join status:

RADIUS authorization is pending for the AP

Error messages on the AP are:

Size soap_cert_crypto_mykey 124

*Mar 1 00:00:35.286: %LWAPP-5-CHANGED: LWAPP changed state to JOIN

*Mar 1 00:00:41.287: LWAPP_CLIENT_ERROR_DEBUG: spamHandleJoinTimer: Did not rec

ieve the Join response

*Mar 1 00:00:41.287: LWAPP_CLIENT_ERROR_DEBUG: No more AP manager IP addresses

remain.

*Mar 1 00:00:42.410: %SYS-5-RELOAD: Reload requested by LWAPP CLIENT. Reload Re

ason: DID NOT GET JOIN RESPONSE.

*Mar 1 00:00:42.410: %LWAPP-5-CHANGED: LWAPP changed state to DOWN

Please help

3 REPLIES
Gold

Re: Upgrade of AP 1231 to lwapp, no join

Make sure you added the AP's mac address to the AP authorization list. Typically that message means that the AP's mac address and the SSC hash were not added.

Community Member

Re: Upgrade of AP 1231 to lwapp, no join

Hello,

I tried to add the MAC under that tab, but could not find out how to obtain the sha1 hash it is asking for.

Community Member

Re: Upgrade of AP 1231 to lwapp, no join

Finally figured it out. Works like a champ. I just overlooked how to get the hash from the controller.

debug pm pki enable

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a008072d9a1.shtml#cause4

1944
Views
0
Helpful
3
Replies
CreatePlease to create content