10-21-2005 01:56 PM - edited 07-04-2021 11:14 AM
i upgraded with the cac tool and was able to get back to it thru the console and the http but the radio will not enable
message in event log is Interface Dot11Radio0, failed - cmd busy any ideas? Mike Emenaker valley view hospital memenaker@vvh.org
10-22-2005 06:19 AM
Now that you have IOS running, update to a newer version (I think 12.3(7) is current).
You can use the GUI (System Software | Software Update) or the CLI
Cherbourg2#archive download-sw /reload /overwrite tftp://
When you do software updates, make sure your radios are shut down to prevent unintentional interruption of the download.
If something FUBARs, DON'T REBOOT THE AP ... you still have operating code. If you reboot and the code is missing or corrupt, then you end up at the monitor prompt and recovery is a bit more tedious.
Good Luck
Scott
10-25-2005 08:35 AM
i have ran the shutdown command,yet the DOT11-2-RADIO_FAILED: Interface Dot11Radio0, failed - cmd busy continues.
Virtual-Dot11Radio0 is administratively down, line protocol is down
Hardware is Virtual Dot11 interface, address is 0000.0000.0000 (bia 0000.0000.
0000)
MTU 1500 bytes, BW 11000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters 3d19h
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue :0/30 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
how do i get the radio to stop running so i can get the new image to copy?
thanks,
i must be missing something
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: