Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

upgrade on aironet1200 to ciscc ios failed

i upgraded with the cac tool and was able to get back to it thru the console and the http but the radio will not enable

message in event log is Interface Dot11Radio0, failed - cmd busy any ideas? Mike Emenaker valley view hospital memenaker@vvh.org

2 REPLIES
Green

Re: upgrade on aironet1200 to ciscc ios failed

Now that you have IOS running, update to a newer version (I think 12.3(7) is current).

You can use the GUI (System Software | Software Update) or the CLI

Cherbourg2#archive download-sw /reload /overwrite tftp:///

When you do software updates, make sure your radios are shut down to prevent unintentional interruption of the download.

If something FUBARs, DON'T REBOOT THE AP ... you still have operating code. If you reboot and the code is missing or corrupt, then you end up at the monitor prompt and recovery is a bit more tedious.

Good Luck

Scott

New Member

Re: upgrade on aironet1200 to ciscc ios failed

i have ran the shutdown command,yet the DOT11-2-RADIO_FAILED: Interface Dot11Radio0, failed - cmd busy continues.

Virtual-Dot11Radio0 is administratively down, line protocol is down

Hardware is Virtual Dot11 interface, address is 0000.0000.0000 (bia 0000.0000.

0000)

MTU 1500 bytes, BW 11000 Kbit, DLY 1000 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

ARP type: ARPA, ARP Timeout 04:00:00

Last input never, output never, output hang never

Last clearing of "show interface" counters 3d19h

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: fifo

Output queue :0/30 (size/max)

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

0 packets input, 0 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 input packets with dribble condition detected

0 packets output, 0 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier

0 output buffer failures, 0 output buffers swapped out

how do i get the radio to stop running so i can get the new image to copy?

thanks,

i must be missing something

228
Views
0
Helpful
2
Replies
CreatePlease to create content