Thanks...I followed the steps in this procedure and all went well until about an hour in to the process I got an error stating that the manifest file was not in the bundle. At this point the transfer stopped and the tftp server shut down
Use the following command to upgrade from NCS 1.0 to NCS 18.104.22.168: # application upgrade NCS-upgrade-bundle-22.214.171.124.tar.gz wcs-ftp-repo In the preceding command, NCS-upgrade-bundle-126.96.36.199.tar.gz is the upgrade bundle file, which is available for download. The repository used in the example, wcs-ftp-repo, can be any valid repository. Examples of repository configurations follow. FTP Repository: # configure (config)# repository wcs-ftp-repo (config-Repository)# url ftp://ip-address (config-Repository)# user ftp-user password plain ftp-user (config-Repository)# exit (config)# exit # SFTP Repository: # configure (config)# repository wcs-sftp-repo (config-Repository)# url sftp://ip-address (config-Repository)# user ftp-user password plain ftp-user (config-Repository)# exit (config)# exit # TFTP Repository: # configure (config)# repository wcs-tftp-repo (config-Repository)# url tftp://ip-address (config-Repository)# exit (config)# exit #
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...