I'm trying to upgrade an Air-AP1230A-A-K9 using the AIR-MP21G-A-K9 upgrade module and the new 802.11g radio will not enable. I have upgraded the software to c1200-K9w7-tar.123-8.JA2, restarted the access point and it still will not start. I have read just about everything in the forums etc. on similar issues but have not seen a solution yet. Does anyone have a solution?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...