Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Upgrade WISM to 6.0.188

I am going to upgrade my WISMs to 6.0.188 from the GUI. In the install notes it say's to shut down the controller port-channel.

When I do so I can't get to the controllers to start the download. If I download the new IOS will the controller

automatically reboot? If so not sure how this would be done. Do you shut down the port channel after the re-load starts?


Thanks for the help!

Pete

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Upgrade WISM to 6.0.188

What you should do is move your ap's off one of the WLC's and then upgrade that WLC to 6.0.188.  Then move AP's

back to that WLC making sure everything works.  then move all you ap's to the upgrade

WLC and upgrade your other WLC on that WiSM.  You will have to reboot the WLC after the upgrade though.

-Scott
*** Please rate helpful posts ***
2 REPLIES
Hall of Fame Super Silver

Re: Upgrade WISM to 6.0.188

What you should do is move your ap's off one of the WLC's and then upgrade that WLC to 6.0.188.  Then move AP's

back to that WLC making sure everything works.  then move all you ap's to the upgrade

WLC and upgrade your other WLC on that WiSM.  You will have to reboot the WLC after the upgrade though.

-Scott
*** Please rate helpful posts ***
New Member

Re: Upgrade WISM to 6.0.188

Thanks for the help I did just that. The change went fine.

512
Views
0
Helpful
2
Replies
CreatePlease to create content