Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Uplink on the WLC 2100 series

Hello,

I haven't understood something in the Cisco documentation of the WLC 2100 series. In fact, on the data sheet it is mentioned that the WLC 2100 "Provides eight 10/100 Ethernet ports, intended to support a combination of access points and redundant LAN uplinks" while in the configuration guide it is mentioned that the WLC 2100 does not support LAG (Link aggregation). So how WLC 2100 can use a redundant uplink to the network without link aggregation?

Thank you in advance.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Uplink on the WLC 2100 series

You can use one port for the management and ap-manager interface, and any other for a specific vlan used for your wlan ssid along with connecting access points to your WLC. this way you can say that port 1 is your management and ap-manager, port 2 is for your internal ssid vlan x, port 3 is for your voice ssid vlan x, port 4 is for guest traffic, port 5 & 6 is to connect two access points.

-Scott
*** Please rate helpful posts ***
1 REPLY
Hall of Fame Super Silver

Re: Uplink on the WLC 2100 series

You can use one port for the management and ap-manager interface, and any other for a specific vlan used for your wlan ssid along with connecting access points to your WLC. this way you can say that port 1 is your management and ap-manager, port 2 is for your internal ssid vlan x, port 3 is for your voice ssid vlan x, port 4 is for guest traffic, port 5 & 6 is to connect two access points.

-Scott
*** Please rate helpful posts ***
404
Views
0
Helpful
1
Replies
CreatePlease to create content