Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Using Multiple 871W Routers to Create a Single Wireless Network

My company purchased 5 Cisco 871 W Wireless routers, and we'd like to configure them to act as single wireless LAN so that users can move around the building with their wireless devices and not experience an interruption in their connection. What do we need to do to make that happen?

2 REPLIES
New Member

Re: Using Multiple 871W Routers to Create a Single Wireless Netw

This will work fine as long as you are only performing layer 2 roaming. If each 871s WLAN resides within a different subnet the client will need to pick up a new IP address each time it moves between Routers.

If all Routers are configured within the same client subnet then the SSID and security settings will also need to match on each 871.

Bear in mind if you are using 802.1x auth then a full re-auth will be required for each roam as there is no central key management which will increase latency.

Lastly AP placement and channel settings are most important, remember for data to have a cell boundary of -75dBm with a cell overlap of 10% sticking to channels 1,6,11.

Will you be running voice on the WLAN?

Hope this helps.

Mat

New Member

Re: Using Multiple 871W Routers to Create a Single Wireless Netw

Thank you very much for the information. This helps a lot. We're not planning to run voice on the WLAN, only data.

239
Views
5
Helpful
2
Replies