Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Using multiple SSID with AP 1100 (standalone mode).

Hi, need to configure 2 SSID on the same 1100 AP: open authentication and WPA2. It's possible to configure these 2 SSID without configuring VLAN's ?

On CCO I've read the following:

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_qanda_item09186a008009483e.shtml

Q. How many service set identifiers (SSIDs) can you have per VLAN?

A. You can have only one SSID per VLAN. The use of multiple SSIDs over a single VLAN is not supported with Aironet APs.

It's also true with the latest IOS release ?

1 REPLY
Hall of Fame Super Red

Re: Using multiple SSID with AP 1100 (standalone mode).

Hi Roberto,

Hopefully the attached docs will answer your question:

Cisco Aironet 1100 Series

Using VLANs with Cisco Aironet Wireless Equipment

Deprecated versions of Cisco Aironet software permit binding multiple SSIDs to one VLAN. Current versions do not.

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_example09186a00801d0815.shtml#

Cisco IOS Software Configuration Guide for Cisco Aironet Access Points, 12.2(15)JA

Configuring Multiple SSIDs

vlan vlan-id

(Optional) Assign the SSID to a VLAN on your network. Client devices that associate using the SSID are grouped into this VLAN. You can assign only one SSID to a VLAN.

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_guide_chapter09186a00802085c4.html

Hope this helps!

Rob

Please remember to rate helpful posts.......

813
Views
0
Helpful
1
Replies
CreatePlease to create content