cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
788
Views
0
Helpful
6
Replies

VLANs in WLC

vishalpatil86
Level 1
Level 1

HI,

I went through below link

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008073c723.shtml

I have the same setup except the dhcp.

I have dhcp server which is givng IP to clients; I want to divide clients as bulding 1 and building 2 with vlan

But they should get IP from same dhcp server

how can I do it?

6 Replies 6

nikhilcherian
Level 5
Level 5

Have you created ap-group per building and did interface over-ride

Thanks

NikhiL

what is interface override???

I have lag enabled on wlc

Configure it like this

Create AP-Groups in the WLC for each of the building

Create dynamic interfaces for each building

Under WLAN>Ap-Groups, add each AP in each building, in the respective AP-Groups

Map the WLAN to the AP-groups to the interface for each building ( you can see an option, Add interface mapping in the document you sent)

Thanks

NikhiL

what about the vlan,

i need to configure vlan 4000 and 4001

first buldng aps will be in vlan 4000 and second bldng will be in 4001

right now i have only 4001 enabled

Create VLAN 4000 also and configure the AP port in VLAN 4000. If you want the client to get ip address in vlan 4000, create a dynamic interface in the WLC in vlan 4000 and map it to the WLAN

Thanks

NikhiL

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: