Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VTY line configuration on a 1042

Hello,

I'd like to know if there is any command to configure the vty line interfaces on the AP with the console cable so without going through the wlc. My point is to configure SSH and telnet on vty 0 to15. When I checked the matching box on the wlc, I see in the config:

line vty 0 4

   transport input all (instead of none)

But as it is a LAP, I don't have any 'conf t' or vty command.

Do you know how to?

Thanks

Theophile

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

VTY line configuration on a 1042

That is a lightweight AP so you can't do that.  You first need to allow telenet and ssh on the AP once it joines the wlc and then you can set your login credentials.  The controller manages all the lightweight AP's so there is a limited amount of cammands that can be ran on the LAP's.

-Scott
*** Please rate helpful posts ***
1 REPLY
Hall of Fame Super Silver

VTY line configuration on a 1042

That is a lightweight AP so you can't do that.  You first need to allow telenet and ssh on the AP once it joines the wlc and then you can set your login credentials.  The controller manages all the lightweight AP's so there is a limited amount of cammands that can be ran on the LAP's.

-Scott
*** Please rate helpful posts ***
406
Views
0
Helpful
1
Replies