Looking at the Cisco Aironet 3500e. When it is ceiling mounted, all 6 antennas are directed vertically towards the floor. When the AP is wall mounted, I guess the antennas should be adjusted at the hinge joint to be vertical. However, the antennas are longer than the spacing between them which means they can't be oriented directly vertical.
Instead of | they're going to look like |
Is that satisfactory according to installation practice? Can't see away around it unless the access point is rotated by 90 degrees then the antennas can be mounted vertically without colliding with their neighbors.
Confirm, it's the only possibility to wall mount the AP rotated 90° (all of my 1260 are mounted that way, with 5 GHz upside and secured with a cable tie). It's some kind of a design flaw from the developers of this casing.
But if you turn off the LED nobody would take a closer look at it.
According to my Cisco PSS, SE, and Advanced wireless team the 3502e and 3602e should have two antennas pointed towards the ceiling, two pointed at the floor, and the middle two pointed out to the sides with the Cisco logo upright and readable. I would assume that the 1262 would be the same. I had this same question a couple of months ago.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...