Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WAP supported in WCS

Hi Expert,

I'd like to know how many Wireless AP Model can WCS supported for design, I mean I want to design Wireless for building and I am using WCS but I didn't find 1602 model from Cisco, I want to know if there is some files I have to updated.

 

I am using a trial version 7.0

 

Thanks for all

 

Mohammad Saeed

Everyone's tags (1)
7 REPLIES
Hall of Fame Super Gold

What APs will depend on the

What APs will depend on the firmware version of your WLC.  

 

So if your the firmware of your WLC is "supported" by WCS then the AP will.  

 

If you have AP1600, then you'll need WLC running firmware version 7.4.100.X.  Officially, this version (7.4.100.X) is not supported.  Unofficially, this version can be supported, in a limited way, by WCS.

New Member

Hi Leo,I want to use AP 1602

Hi Leo,

I want to use AP 1602 model for design and planning, i can't found it there in the AP list.

 

 

New Member

I am going to use 1602 type

I am going to use 1602 type in my project and I need to make a simulation design through WCS, but I didn't find it, Is there any kind of AP can be the same of 1602?

 

Many thanks

Hall of Fame Super Gold

Hi Mohammad,  I believe you

Hi Mohammad, 

 

I believe you are NOT READING what I've posted.  cheeky

 

Let me repeat what I've posted above:  Your AP will depend entirely on the firmware your WLC runs on.  For an AP1600, your WLC should be running a firmware of 7.4.100.X.  If your WLC can run this version, then, potentially, your WCS can "see" your WLC as well as your AP.  

 

HINT #1:  What is the exact model of your WLC?

HINT #2:  Can your WLC support firmware version 7.4.100.X? 

Read the following documents:

Supported Cisco Wireless LAN Controller Platforms for 7.4.110.X

Software Release Support for Access Points

 

New Member

Hi Leo, I understand this

Hi Leo,

 

I understand this issue in WLC! but I want to make design for my project and I didn't connect to WLC and I want to use map option and make simulation design before I install any thing in the Site! do you understand me NOW? cheeky

 

I hope that!

 

Thanks

New Member

any reply!

any reply!

Hall of Fame Super Gold

I want to make design for my

I want to make design for my project and I didn't connect to WLC and I want to use map

If you are new to wireless then I would suggest you get a proper wireless site survey done.  

 

I've seen, many of times, of novice who, without any knowledge in enterprise-grade wireless deployment, say "here and here, deploy the AP" and get it wrong.   It doesn't matter if you are using WCS' "planning" feature, you still won't get it right.  WCS' "planning" feature only serves as a "guide" and not a definite or conclusive way to determine how-many APs and where-to-install the APs.  

 

Wireless site survey, second to none.  Period.

62
Views
0
Helpful
7
Replies
CreatePlease to create content