Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WAP121 as a workgroup bridge in a WLC environment

Good morning

To keep consts down a customer of ours wants to use WAP121s as workgroup bridges in place of WET200.

I know that certain of the enterprise WAPs running autonomout IOS can act as properly integrated bridges in a WLC environment (1130s, 1142s etc)

The WET200 sort-of-worked in the WLC environment.

Does anyone know if the WAP121 will work as a properly integrated WGB with a WLC?

Thanks in advance

Robin

4 REPLIES
Hall of Fame Super Silver

Re: WAP121 as a workgroup bridge in a WLC environment

I don't know if you will find much info on this forum about the WAP121 working or not as a WGB. It might be better for you just to try it and see or maybe ask the question in the Small Business Wireless forum. WGB isn't very stable when it's not an IOS autonomous access point being used. I have tested a few and it will work for a day or so, then it needs to be rebooted.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
New Member

WAP121 as a workgroup bridge in a WLC environment

Scott - we found that with the WET200s although it seems to have settled down now.  I've posted in that forum now.

Sandeep - the questions wasn't whether the WAP121 supports CAPWAP - I know that it doesn't - but if it acts as a fully-integrated Workgroup Bridge client associated with an access point running with a WLC.

I now suspect that it doesn't because the WGB mode on a WLC infrastructure requires Aironet IE enhancments and I can find nothing on the WAP121 documentation to suggest that it will support that.

The WAP121s are cheap enough that the customer is going to try one - if there is only one client on the wired side then MAC address spoofing may be enough for it to work.

I'll post back here if I have any additional information.

Thanks

Regards

Hall of Fame Super Silver

Re: WAP121 as a workgroup bridge in a WLC environment

I have tried using various SOHO Ethernet bridges and they do connect, but eventually they just stop working. The older Linksys seemed to work better than the newer one and that's the same with the Buffalo bridges.

Let us know if the WAP121 is stable or not when your customer tries it out.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
VIP Purple

WAP121 as a workgroup bridge in a WLC environment

Hi Robin,

This AP is not supported to run as CAPWAP

You cannot do it to Cisco WAP121 Wireless-N Access unlike Cisco Aironet series APs.

There is a feature that comes with the WAP100 and WAP300 series Access Points. It is called Single Point Setup.

You can read about it in the Admin Guide located here:

http://www.cisco.com/en/US/docs/wireless/access_point/csbap/wap121/administration/guide/WAP121_321_AG_en.pdf

Regards

Dont forget to rate helpful posts

365
Views
0
Helpful
4
Replies