I have a real simple setup and I assume a very simple solution.
I am setting up a wireless network for a user using a WAP321 access point, for the most part the coverage is ok in the house (very big house), however there are a few bad spots, my hope is that I could setup another WAP321 that could feed off the wireless of the other and maybe help the coverage without any disconnects from one to the other?
I am fairly new to this concept, do the two access point have to be in sight of each other? Does the second one I put in place need anything other than power?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...