When I enter a valid SMTP address on the WAP4410N Wireless Access Point in the Administration > Log section (to receive log alerts), the AP stops responding when I click "Save". I finally have to force close the browser window and the settings are not saved.
Any ideas how to overcome this bug? I'm using firmware version 188.8.131.52.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...