Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

WAP561 Autonegotiation fails

Hi,

yesterday ive got my WAP561. I fidured out that he is not able to establish a Network Connection to my Netgear POE Switch (GS110TP). The Port stays down. So i tryed it with an POE Injector and an HP1810G Switch. Again no Link. Wenn i attach the Link from the Injector to my Laptop i get an link.
Same with AP -> INJECTOR -> Netgear FS106.

On all Switches AutoNeg is enabled.
I disabled Autoneg on the AP and set it to 100M FullDuplex, and it works.
But this cant be the solution. So why is this AP not able to autoneg with my Switches.

Second thing i figured out is, that im not able to set a Username with a dash (-) for MailServer authentication. So at the moment the AP is unusable to me.

Firmware is the latest (1.0.4.4)

regards from germany.

Johannes Häfner

Everyone's tags (1)
1 REPLY

Online Device EmulatorBrowse

Online Device Emulator

Browse through Cisco Small Business product management and configuration features to see firsthand how you can enhance business operations.
Specifications at a Glance
Specifications     Description
Interfaces     10/100/1000BASE-T autosensing (RJ45)
Powering options     802.3af Ethernet switch, Cisco SB-PWR-INJ-12V-xx power injector
Radio     802.11n dual concurrent radio (Cisco WAP561) or selectable single radio (Cisco WAP551)
Wireless     802.11n, 3 x 3 multiple-input, multiple-output (MIMO)
Operating Modes     Access point mode, wireless distribution system (WDS) bridging, Workgroup Bridge
VLAN Support     Yes
Multiple SSIDs     16

55
Views
0
Helpful
1
Replies
CreatePlease to create content