I am connecting a 2950 Switch to my workgroup bridge (350) and I am not able to see the switch.
I have Vlan100 setup with IP address 10.188.100.7 and the WB has 10.188.100.6. For some reason they cannot see each other? The WB can ping and see the WAP at 10.188.100.5, but not the switch that is directly connected?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...