Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WCS AP Setting - Antenna Mode - What does it do?

Hello,

I'm working configuring our wireless networking. When setting up AP templates in WCS I came across a setting that I'm not sure of and haven't been able to find anything about.

What is Antenna Mode and what does it do? There are three options that I've seen..

Sector A

Sector B

OMNI (Sector A and Sector B)

Does anyone know what these settings do?

Thank You!

Eric

4 REPLIES
Green

Re: WCS AP Setting - Antenna Mode - What does it do?

Sector A = "Front"

Sector B = "Rear"

Omni = Front + Rear radiation pattern

Good Luck

Scott

New Member

Re: WCS AP Setting - Antenna Mode - What does it do?

I'm guessing that by default they are going to be set to Omni correct? Or is this something I should push through the AP Template?

Green

Re: WCS AP Setting - Antenna Mode - What does it do?

I believe Omni is the default.

Good Luck

Scott

New Member

Re: WCS AP Setting - Antenna Mode - What does it do?

Thanks for the info!

408
Views
0
Helpful
4
Replies