Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WCS is not seeing any AP's but see's the 4400

I have WCS, A 4400 and 1130ag access points. WCS see's the 4400 but none of the ap's

1 ACCEPTED SOLUTION

Accepted Solutions

Re: WCS is not seeing any AP's but see's the 4400

Hmmm... Are these APs running in lwapp or autonomous mode? They need to be in lwapp (lightweight) mode in order to be controlled by the controller

6 REPLIES

Re: WCS is not seeing any AP's but see's the 4400

Does the 4400 see the APs?

New Member

Re: WCS is not seeing any AP's but see's the 4400

Only with the cisco discovery service. I can ping them.

Re: WCS is not seeing any AP's but see's the 4400

Hmmm... Are these APs running in lwapp or autonomous mode? They need to be in lwapp (lightweight) mode in order to be controlled by the controller

New Member

Re: WCS is not seeing any AP's but see's the 4400

The rep sent the wrong AP's had to exchange 120 autonomous for LWAPP

Thanks

New Member

Re: WCS is not seeing any AP's but see's the 4400

I've seen the same problem. I've had to refresh the configuration from the controller to my WCS server. After doing that I was able to see all my AP's.

New Member

Re: WCS is not seeing any AP's but see's the 4400

Thanks, but the rep sent the wrong AP

152
Views
0
Helpful
6
Replies