I am running a WCS 18.104.22.168 with WiSM on a 6509 series switch. the problem is that the WCS is not able to generate heat map for the access points installed on a remote site. th AP mode is local. the WLC on the WCS are in a reachable state. I can see the access points on the WCS but the antenna are specified as other and i cannot generate the RF frequency on the maps.
for the release note of this WCS version is stating that both the WiSM and the access points are supported.
Please check the error i am having on the WCS and the release note for the WCS version
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...