Ensure that the mobility network-id command is not enabled on the Cisco Access Point (AP) if it serves as the Wireless Domain Services (WDS) device. The mobility network-id command is used for Layer 3 (L3) mobility, and the AP configured as a WDS cannot provide L3 mobility. This command must only be enabled when a Wireless LAN Services Module (WLSM) is used to provide WDS. A WLSM must be the WDS device to properly configure L3 mobility.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...