Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

WGB cannot associate to WiSM

All,

I have WiSM rev 4.1.185.0. I try to make some WGBs using LEAP and TKIP together with a client username and password. However, no matter what I do the WGB cannot associate.

The documentation I found on this only goes as far as wep, no TKIP/AES and no leap explained. Does anyone have a sample config? Does anyone have a URL for me which I might have overseen?

--Joerg

1 REPLY
Silver

Re: WGB cannot associate to WiSM

Configure the command "encryption mode ciphers tkip " under the dot11 Radio interface configuration mode.

157
Views
0
Helpful
1
Replies
CreatePlease to create content