Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Will a reset on a 1242 to factory defaults...

I have a 1242 that was configured for LWAPP and I reset to factory defaults. I'm curious if it returned to autonomous mode?

Thanks in advance

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Will a reset on a 1242 to factory defaults...

It should not have.  When you migrate from IOS to CUWN, the process removes all of the old IOS that was there, erases the flash basically.

So, a factory reset should only clear out any configuration, but would leave you running a CUWN image on the AP.

Cheers,
Steve

--

If  this helps you and/or answers  your question please mark the question as "answered" and/or rate it, so  other users can easily find it.

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
1 REPLY

Re: Will a reset on a 1242 to factory defaults...

It should not have.  When you migrate from IOS to CUWN, the process removes all of the old IOS that was there, erases the flash basically.

So, a factory reset should only clear out any configuration, but would leave you running a CUWN image on the AP.

Cheers,
Steve

--

If  this helps you and/or answers  your question please mark the question as "answered" and/or rate it, so  other users can easily find it.

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
995
Views
0
Helpful
1
Replies