Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

wired guest config error: Learn Client IP Address

Hi

I get the following error message when I want enable a wired guest lan on WiSM2

have anyone an idea whats the problem? The Learn Client IP Address is only available when I configure a FlexConnect Access Point.

I use the Version 7.6.120.0

Thank you for your help

Best Regards

Kurt

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Try to delete the guest

Try to delete the guest interface and the guest lan and create it again.  I had no issue creating the guest lan on a 5508 running v7.6.120.0

Scott

-Scott
*** Please rate helpful posts ***
4 REPLIES
Hall of Fame Super Silver

There is no problem there...

There is no problem there... That option is only available on FlexConnect, not local mode nor wired. 

Scott

-Scott
*** Please rate helpful posts ***
New Member

Hello ScottThank's for your

Hello Scott

Thank's for your response.

I know, but why I get this error message on a wired Guest Lan when I wnat enable the WLAN?

see attached picture.

Kurt

Hall of Fame Super Silver

Try to delete the guest

Try to delete the guest interface and the guest lan and create it again.  I had no issue creating the guest lan on a 5508 running v7.6.120.0

Scott

-Scott
*** Please rate helpful posts ***
New Member

Thanks Scott, it was the

Thanks Scott, it was the right thing. I've deleted all 4 wired guest lan and created new and now it workes propperly. The problem was occured after upgrade to the new version.

I will test in the labor if this problem occours on each upgrade or if it was a single failor.

Kurt

89
Views
5
Helpful
4
Replies
CreatePlease login to create content