I am not very good at wifi... but we just setup a wifi system. Someone brings up an question... In a single conference room...let's say...about 1000 square feet conference room. Currently I have a AP mounting on the top wall. It is working fine. But let's say...there will be fifty..more or less people using connected to the single AP, would that affect the performance a lot?
Or if we add additional 2, or 3 more APs. WOuld that help the network performance/...or any kind of performance? The person mentioned about "density".
After renewing my CCNP...I will definitely buy a book to study for the wireless cert!
All depends on the content. If you plan to do video and voice in this room on many of the 50 concurrent clients you will for sure feel some pain. It all goes back to how the 802.11 medium works. Its a half duplex medium. So only ONE client can talk at a time, "listen and then speak".
Normal web browsing you could get away with 1 ap, but would advise 2. If this is video / voice perhaps 3 aps. Low power, non conflicting channels. I might even advise direction anetnnas to better direct the coverage in the room. Again, I am not there or know what the room looks like but just making suggestions.
"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...