02-19-2003 09:28 AM - edited 07-04-2021 08:31 AM
I have two aironets about a mile apart that randomly lose their association and then re-associate. Other bridges connecting to the root bridge do not have this problem. This issue started when I upgraded the firmware last year - it went away once the firmware was upgraded to the current version - and has now started again. Any ideas ?
02-20-2003 07:33 PM
a) Make sure you are running latest 12.01 firmware
b) Go to Radio hardware page , try increasing beacon period to 4000 instead default 100 .
c) This bridges works in unlicence band so we need to
verify that there is no interference in that area .
Run link test and switch over to less busy channel
d) Check antenna alignment , RF connector again .
Coax cable between bridge and antenna should be as short as possible.
e)If possible run the bridge in default config ( without
encryption ) and see if you get same problem
f) hardcode the speed to 1 meg and see if links remains steady
03-11-2003 07:04 PM
where can I find information about the beacon period and the impact of increasing and decreasing the value.
Dan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: