Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Wireless config on 2811 with hwic access point.

I am running 2811 (ios 12.4(9)T) router with a 4 port switch module (HWIC-4ESW-POE=) and wireless module (HWIC-AP-G-E=).

What i would like to do is set up the wireless access point to be on the same network as the switch. But for now i'm trying to set up the Access Point as its own network and i will worry about bridging the devices later.

I've got the following configuration from reading http://www.cisco.com/en/US/products/ps6441/products_configuration_guide_chapter09186a00805d90f0.html

interface Dot11Radio0/2/0

ip address 192.168.30.1 255.255.255.0

!

ssid WLAN

authentication open

!

speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0

station-role root

!

interface Vlan1

ip address 192.168.20.1 255.255.255.0

ip virtual-reassembly

!

Am i right in believing that the SSID isnt broadcast as default? How would i turn this on?

I have SDM v2.3.2 with wireless application installed so if that's easier to explain it's available.

Thanks.

1 REPLY

Re: Wireless config on 2811 with hwic access point.

correct the SSID is not broadcast by default. the command you are looking for to turn it on is guest-mode. Issue this under the SSID on the DotRadio interface.

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
286
Views
0
Helpful
1
Replies