Re: Wireless connectivity issue between Cisco AP and Symbol clie
SInce the Linksys was able to communicate with the 1200 it is most likely a firmeware issue with the Symbol or a configuration issue. First try to reconfigure the Symbol to match the SSID or ESSID of the 1200. Remember that the SSID is case sensitive. If this does not work then go to Symbol's website and download the latest firmware and drivers for the card that match your operating system. According to their configuration PDF files on their site they recommend upgrading to the latest versions because the firmware that came on the CD might be a version or two older than what is current.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...