Re: Wireless connectivity issue between Cisco AP and Symbol clie
SInce the Linksys was able to communicate with the 1200 it is most likely a firmeware issue with the Symbol or a configuration issue. First try to reconfigure the Symbol to match the SSID or ESSID of the 1200. Remember that the SSID is case sensitive. If this does not work then go to Symbol's website and download the latest firmware and drivers for the card that match your operating system. According to their configuration PDF files on their site they recommend upgrading to the latest versions because the firmware that came on the CD might be a version or two older than what is current.
< PRE >
(#)For this reason being that : - application that doesn't use multicast, sends one copy of each packet ( data unit of traffic at layer 3 ) to each client (" who seeks the traffic ).- application that does use multicast, sends ...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...