Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Wireless controller issues

I have just deployed a 4402 wireless controller and updated autonomous 1231 aironets to lightweight mode. All works ok.

I create an interface on a vlan and added IP addresses etc.

Whenever i attempt to associate a WLAN with the interface the only interface available is Management

Another problem is if I create a interface and dont enable Dynamic AP management I loose access to the controller and have to remove the interface via the service port.

Any ideas would be welcome

2 REPLIES

Re: Wireless controller issues

On the WLC, is the newly created interface enabled?

You should enable dynamic ap management on the management interface or other interface, not a dynamically created interface for client traffic.

Is the port from the switch to WLC in trunk mode?

New Member

Re: Wireless controller issues

Confirm the following:

1.) Management and AP-Manager interface are on a single VLAN.

2.) Dynamic Interface is on a different VLAN and enabled.

3.) Both VLAN's exist on the connected switch.

4.) The connected switch port is configured as a dot1q trunk including both VLAN's listed above.

158
Views
0
Helpful
2
Replies
CreatePlease to create content