07-07-2007 05:23 AM - edited 07-03-2021 02:18 PM
I have just deployed a 4402 wireless controller and updated autonomous 1231 aironets to lightweight mode. All works ok.
I create an interface on a vlan and added IP addresses etc.
Whenever i attempt to associate a WLAN with the interface the only interface available is Management
Another problem is if I create a interface and dont enable Dynamic AP management I loose access to the controller and have to remove the interface via the service port.
Any ideas would be welcome
07-09-2007 10:11 AM
On the WLC, is the newly created interface enabled?
You should enable dynamic ap management on the management interface or other interface, not a dynamically created interface for client traffic.
Is the port from the switch to WLC in trunk mode?
08-24-2007 10:44 AM
Confirm the following:
1.) Management and AP-Manager interface are on a single VLAN.
2.) Dynamic Interface is on a different VLAN and enabled.
3.) Both VLAN's exist on the connected switch.
4.) The connected switch port is configured as a dot1q trunk including both VLAN's listed above.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide