I am intending to manually reset the LWAPP (1131), however, is there a way to access the LWAPP CLI? Currently, the LWAPP is stuck in a loop, thus debug message on the LAP display " No Join Response from WLC". So, because of this recurring loop, the LAP is not settling at a command prompt. Is there a way to break this cylce so I can enter in the command to point to a WLC ?
Yes, that is correct....I wanted to envoke "config term" and was not able to do so.Perhaps because the type of image on the AP, which you say is the LWAP RCV image. All I simply wanted to do, in an attempt to fix the discovery issue between the AP and the WLC, is to configure the LWAPP with an IP address and the IP Address of the WLC, as per the documented proceedure when a LWAPP is unable to join the WLC. It just seems trivial for Cisco to load onto a brand new LWAPP unit an IOS image such as; LWAP RCV image, by default, right out of the box. Because this image type complicates a troubleshooting scenario when the LWAPP is unable to join the WLC. How come the documented procedure, instructing the user to configure IP addresses, neglected the facts about image type?
Anyhow......the problem has been resolved and fortunately, I was spared into having to replace the IOS image. The problem was the time clock on the brand new WLC. After correcting the time clock, the LWAPP was able to join the WLC. One of the troubleshooting pages provided a long list of links to view when an LWAPP is unable to join the WLC.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...