Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Wireless Problem

Hello,

I have just implemented my first 877w router.

I used the gui for the configurations (excluding the wireless part).

I then followed a cisco tutorial in setting up wireless (the one with the ssid and relating it to vpn1).

I did all the tutorial except for the bridging part which I assume I don't need.

However, when I do: #show .. associations

(where .. is the word that includes an 11 in it -can't remember it from the top of my head-)

I see my only SSID linked to VPN as 'DISABLED'. I tried lots of things including no shutdown in the ssid mode, shutdown vpn1 (thinking I can re enable it - but guess what I lost my telnet session, lol).

I googled for a bit, but I wasn't able to find a solution.

How can I fix this?

Thanks in advance

2 REPLIES
Bronze

Re: Wireless Problem

VPN is supported for wired modules and not for wireless serives.Refer URL

http://www.cisco.com/application/pdf/en/us/guest/products/ps5854/c1650/cdccont_0900aecd8016ef57.pdf

New Member

Re: Wireless Problem

what you need to do is bridge vlan1 and your wireless into bridge-group 1

Then you setup BVI1 (bridge-group 1) with the IP address, access-lists etc that you want

Then apply your vpn crypto map to your dialer0 interface and there you have it.

Traffic from both your wi-fi and wired devices will go across your VPN

If you email me your config I can have a look at it and make the changes that you need and send it back to you

eagleeyes426@yahoo.com

141
Views
0
Helpful
2
Replies