Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Bronze

Wism and RF Group Problem

We have on Wism version 4.0.155.5. We configured one RF group name for two controllers in the wism and use auto-RF. The problem is each controller can only see itself in the RF group and consider itself as the RF group leader. My understanding is each one should see two controllers in the RF group and only one should be the RF group leader. Where could be wrong?

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Wism and RF Group Problem

I posted the following in your other thread:

Do you have APs on both WiSMs yet? They will only see other RF group members that have APs associated to them. I had the same issue, but when I moved 1 AP to each WiSM the RF group came up as expected.

4 REPLIES
Community Member

Re: Wism and RF Group Problem

I have a test setup here in the lab running the same software, and i see exactly the same thing.

In the RF group they only see themselves, and they are both group leader.

Looks like a software glitch. A Cisco engineer reading this?

Silver

Re: Wism and RF Group Problem

I posted the following in your other thread:

Do you have APs on both WiSMs yet? They will only see other RF group members that have APs associated to them. I had the same issue, but when I moved 1 AP to each WiSM the RF group came up as expected.

Community Member

Re: Wism and RF Group Problem

Thanx, gonna try this out.

Bronze

Re: Wism and RF Group Problem

Yes that is helpful. Thanks!

276
Views
4
Helpful
4
Replies
CreatePlease to create content