Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Wism Controller 2 doesn't get service port IP but Controller 1 does

I followed the documentation for setting up the WiSM. Controller 1 is up and fine. I see in dhcp bindings, that Controller 2 is getting a DHCP address and when I "session slot 9 pro 2" it tries to connect to that dhcp address, but on a "show wism status" the service-port of controller 2 is 0.0.0.0

Has anyone encountered this problem?

Thanks

1 REPLY
Cisco Employee

Re: Wism Controller 2 doesn't get service port IP but Controller

Hi..

What about the connectivity?? do we still have the access to the WLC 2?? either from telnet or the GUI?? or will the session to the WLC work?

Regards
Surendra

210
Views
0
Helpful
1
Replies