Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

wism startup wizard

Hi,

I am trying to get into startup wizard.basically i issue reset system followed by recover-config at username prompt but wism prompts me for the password.

This was mentioned in the Cisco WLC configuration guide.

Any help is much appreciated.

cheers,

Janesha

----------------------

(WiSM-slot1-1) >reset system

The system has unsaved changes.

Would you like to save them now? (y/N) y

Configuration Saved!

System will now restart!

02:53:21: %WiSM-5-STATE: Controller 1 in slot 1 is Oper-Up

[Connection to 10.0.1.67 closed by foreign host]

wireless7#10.0.1.67

Trying 10.0.1.67 ... Open

(WiSM-slot1-1)

User: recover-config

Password:

5 REPLIES
Silver

Re: wism startup wizard

I believe you can only do this consoled in to the wism directly with the serial connection.

New Member

Re: wism startup wizard

Hi

Thanks Terry.Will try that sometime today.

cheers,

Re: wism startup wizard

Q. How can I reset the WiSM to factory default settings?

A. Complete these steps to reset the WiSM controller to factory defaults:

1. Enter reset system at the WiSM controller CLI.

2. At the prompt that asks whether you need to save changes to the configuration, enter Y or N. The unit reboots.

3. When you are prompted for a username, enter recover-config to restore the factory default configuration. The Cisco WLAN controller reboots and displays this message:

Welcome to the Cisco WLAN Solution Wizard

Configuration Tool

4. The WiSM is now reset to factory defaults. Use the configuration wizard to enter new configuration settings.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_qanda_item09186a00806e39b7.shtml#Q7

If you find this post helpful please rate it

__________________________________________________________________________________________ "Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________
New Member

Re: wism startup wizard

Hi George,

This is exactly the what I followed as mentioned in the config guide 5.2. However, it didn't work.As Terry suggested, I will try to reset the config by directly connecting to wism.

cheers,

Janesha

New Member

Re: wism startup wizard

Hi all,

Found the method to clear config.

It was mentioned on WLC config guide 5.2

http://www.cisco.com/en/US/docs/wireless/controller/5.2/configuration/guide/c52mfw.html.

Thanks for all the help.

cheers

532
Views
0
Helpful
5
Replies