I"m attempting to create a new WLAN on the 5508 controller that will allow access to the corporate network. I'm using WPA + WPA2 layer 2 security with authentication via PSK. When I input the required information and select apply I receive the message: The following errors occurred while updating the WLAN: Error in setting Interface Name. I notice the interface/interface group drop down on the general tab reverts from the network I want to point the WLAN to back to management. Any ideas why?
I'm not sure if it makes a difference but I do have another WLAN that is pointing to the same corporate network but it uses 802.1X authentication.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...