Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Wlan controller and branch office AP (vlan config)

Hi,

Our wlan controller is located in HQ office and we have APs in branch office. Is it possible to implement two different SSIDs and they should be in two different vlans? So should we configure the AP trunk?

REAP does not support IEEE 802.1Q VLAN tagging. As such, it does not support multiple VLANs. Traffic from all the service set identifiers (SSID) terminates on the same subnet, but H-REAP supports IEEE 802.1Q VLAN tagging. Traffic from each SSID can be segmented to a unique VLAN.

Thanks

3 REPLIES
Hall of Fame Super Silver

Re: Wlan controller and branch office AP (vlan config)

Yes it is. The ap mode would be set to h-reap/FlexConnect depending on the code you have on the WLC. You can specify the WLAN to vlan mapping for each SSID. Take a look at this guide.

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00807cc3b8.shtml

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
VIP Purple

Re: Wlan controller and branch office AP (vlan config)

Advantage of H-REAP is you could still have same SSID in your Head Office & Branch, but they can be on two seperate vlans. Have a look below sample configuration I did to understand different method of H-REAP configuration. It is based on the cisco doc Scott mentioned above.

http://mrncciew.com/2013/03/10/h-reap-modes-of-operation/

HTH

Rasika

Re: Wlan controller and branch office AP (vlan config)

Hello,

As per your query i can suggest you the following solution-

Yes, it possible to implement two different SSIDs and they can be in two different vlans.

For more information please refer to the link-

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00807cc3b8.shtml

Hope this will help you.

247
Views
0
Helpful
3
Replies