When you choose Monitor > Clients to open the Clients page.
This page lists all of the clients that are associated to the controller’s access points. It provides the following information for each client:
The MAC address of the client
The name of the access point to which the client is associated
The name of the WLAN used by the client
The type of client (802.11a, 802.11ac, 802.11b, 802.11g, or 802.11n)
If the 802.11n client associates to an 802.11a radio that has 802.11n enabled, then the client type shows as 802.11a/n/ac. If the 802.11n client associates to an 802.11b/g radio with 802.11n enabled, then the client type shows as 802.11b/n.
The status of the client connection
The authorization status of the client
The port number of the access point to which the client is associated
An indication of whether the client is a WGB
To get the RSSI and SNR values, you'd have to perform a Link Test.
The controller shows these link-quality metrics for CCX link tests in both directions (out— access point to client; in— client to access point):
Signal strength in the form of RSSI (minimum, maximum, and average)
Signal quality in the form of SNR (minimum, maximum, and average)
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...