Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WLC 2504 /AIR-LAP1041N

Hello;

I need your help to solve my problem; 

AIR-LAP1041N-E-K9 can't join WLC 2504.

Here some informations from the WLC

(Cisco Controller) >show sysinfo

Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 7.0.220.0
Bootloader Version............................... 1.0.16
Field Recovery Image Version..................... 1.0.0
Firmware Version................................. PIC 16.0


Build Type....................................... DATA + WPS

System Name...................................... CiscoController_88:e2:64
System Location..................................
System Contact...................................
System ObjectID.................................. 1.3.6.1.4.1.9.1.1279
IP Address....................................... 192.168.10.10
Last Reset....................................... Power on reset
System Up Time................................... 0 days 1 hrs 54 mins 59 secs
System Timezone Location.........................
Current Boot License Level....................... base
Current Boot License Type........................ Permanent
Next Boot License Level.......................... base

--More-- or (q)uit
Next Boot License Type........................... Permanent

Configured Country............................... TN  - Tunisia
Operating Environment............................ Commercial (0 to 40 C)
Internal Temp Alarm Limits....................... 0 to 65 C
Internal Temperature............................. +26 C
External Temperature............................. +31 C
Fan Status....................................... 4000 rpm

State of 802.11b Network......................... Disabled
State of 802.11a Network......................... Disabled
Number of WLANs.................................. 1
Number of Active Clients......................... 0

Burned-in MAC Address............................ F0:29:29:88:E2:60
Maximum number of APs supported.................. 5

(Cisco Controller) >show wlan summary

Number of WLANs.................................. 1

WLAN ID  WLAN Profile Name / SSID               Status    Interface Name
-------  -------------------------------------  --------  --------------------
1        homenet / homenet                      Enabled   management

(Cisco Controller) >show interface summary

Interface Name                   Port Vlan Id  IP Address      Type    Ap Mgr Guest
-------------------------------- ---- -------- --------------- ------- ------ -----
inetrface4                       4    untagged 192.168.10.40   Dynamic Yes    No
interface2                       2    untagged 192.168.10.20   Dynamic Yes    No
interface3                       3    untagged 192.168.10.30   Dynamic Yes    No
management                       1    untagged 192.168.10.10   Static  Yes    No
virtual                          N/A  N/A      1.1.1.1         Static  No     No

 

Reagrds and waiting for your reply.

Meher

Everyone's tags (1)
1 REPLY
VIP Purple

HI ,Paste the swicth config

HI ,

Paste the swicth config where WLC connected? and how AP are getting IP ??

1. Paste the entire bootup process from AP console access.

2nd on all interface make the port as "1" (why are you using 2,3,4 port ?)

 

Regards

Dont forget to rate helpful posts

35
Views
0
Helpful
1
Replies
CreatePlease login to create content