12-23-2011 07:44 AM - edited 07-03-2021 09:17 PM
Having an issue with connecting the WLC to an HP
Vlan 1 data
Vlan 2 voice
Vlan 10 WLC
What are the settings on the HP to connect to the WLC?
12-23-2011 08:38 AM
To an extent it depends on the config of the management interface. If you have the management set to be 0, then:
Tag 1
Tag 2
no tag 10.
If you have all interfaces tagged then,
notag 1
tag 2
tag 10.
HTH,
Steve
----------------------------------------------------------------------------------------------------------
Please remember to rate helpful posts or to mark the question as answered so that it can be found later.
12-23-2011 08:49 AM
The Management is set to untagged. So the first settings group is what the switch is set to. I will pass this one, thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: