Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

WLC 2504, directly connected APs

I need to configure a 2504 wlc and two 1142 APs that I want to connect directly to the wlc. I've heard I can't use the PoE on port 3 and 4. If so, can I use power injectors instead?

I can't seem to get the APs to speak to the wlc. Using example below, how would I go about configuring this andwhen do i need to enable Dynamic AP Management? Appreciate all suggestions.

Example:

mgmt vlan 10

guest vlan 20

empolyee vlan 30

Wlan: Guest

Wlan: Employee

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: WLC 2504, directly connected APs

You can use the PoE ports but

Is not Cisco supported. The ap will have to obtain an ip address on the same vlan as the wlc management interface.

Thanks,

Scott Fella

Sent from my iPhone

-Scott
*** Please rate helpful posts ***
2 REPLIES
Hall of Fame Super Silver

Re: WLC 2504, directly connected APs

You can use the PoE ports but

Is not Cisco supported. The ap will have to obtain an ip address on the same vlan as the wlc management interface.

Thanks,

Scott Fella

Sent from my iPhone

-Scott
*** Please rate helpful posts ***
New Member

Re: WLC 2504, directly connected APs

Decided not to use the PoE port on the wlc, but used a regular PoE switch instead.

Thanks for you help!

Sent from Cisco Technical Support iPad App

1328
Views
0
Helpful
2
Replies
CreatePlease to create content