Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

WLC 2504 firmware upgrade

Upgraded my Cisco 2504 from 7.0.220.0 to 7.4.111.0

and upgraded my field upgrade bootloader to 1.0.18.

Now I cannot configure my WLC from the web via IP. Had it configured properly with VLAN, switch and my ASA 5520.

Does this have to do with the ACL's on the WLC.

I've been looking for documentation can't find much in terms of best practices for traffic.

My CPU ACL on wired and wireless are disabled with no ACL for the CPU.

Any suggestions or help would be greatly appreciated.

Thank you

Carlos

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Silver

Re: WLC 2504 firmware upgrade

Well can you console into the WLC at least?

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Hall of Fame Super Silver

Re: WLC 2504 firmware upgrade

The FUS image takes 35-45 minutes. You would need to run that again if you interrupted it. It is suggested to have that fully uploaded

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
5 REPLIES
Hall of Fame Super Silver

Re: WLC 2504 firmware upgrade

Well can you console into the WLC at least?

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Community Member

WLC 2504 firmware upgrade

Hello Scott,

     I figured it out. I had to do from CLI a reset system command. Once I did that everything came back up. I did not know that field upgrade and firmware upgrade took so long. The instructions say to just to a save and reboot. I found out that you need to do a reset system command again from the CLI.

Appreciate the assistance.

Hall of Fame Super Silver

Re: WLC 2504 firmware upgrade

The FUS image takes 35-45 minutes. You would need to run that again if you interrupted it. It is suggested to have that fully uploaded

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Community Member

WLC 2504 firmware upgrade

Hello Scott,

     Yes I reran it and everything is working now. Interesting surprises to say the least. Appreciate all of your help.

Carlos

Hall of Fame Super Silver

Re: WLC 2504 firmware upgrade

Well glad you got it working.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
376
Views
0
Helpful
5
Replies
CreatePlease to create content