Something I didn't understand in the documentation is this.
Is there a replication of configuration between the WLC primary and the HA ? I did read that they should have different network settings (IP addresses) so I understand that there is not a total replication, what about the rest of the configuration ?
The only result I have when I issue a command on the WLC-HA is this
>show redundancy summary
Type of the Unit = Secondary
It doesn't look exactly what I see in the documentation.
Make it simple, configure both WLC independently, so different IP and hostnames. Even the dynamic interface IP address will be different. Then on the AP, configure the high availability in which you put the primary and the secondary WLC hostname (case sensitive) and IP address.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...