WLC 4402 and 5508 with LAG enabled configure for use with HP ProCurve

[mvolk]

Hi @ all,

have anybody an funktional configuration with HP ProCurve Switches to use the LAG (LACP) mode in conjunction with the WLC 4402 or 5508 with Software version 7.0.112.0? The HP Switches in the enviroment have the last Firmware version installed!

I had read the discussion that was posted in 2008, but have anybody make since this time new findings!

With Enterasys Switches I had no problems in the past to setup an LAG configuration.

Thanks for answers!

Marc

https://supportforums.cisco.com/message/1286014#1286014

[Salil Prabhu]

Hi Marc,

NO Not possible. Can they not do just MODE ON .i.e no negotiation

If not, you have to create individual ap-managers to avoid running into any issues.

Thanks..Salil