WLC 4402 and 5508 with LAG enabled configure for use with HP ProCurve
Hi @ all,
have anybody an funktional configuration with HP ProCurve Switches to use the LAG (LACP) mode in conjunction with the WLC 4402 or 5508 with Software version 184.108.40.206? The HP Switches in the enviroment have the last Firmware version installed!
I had read the discussion that was posted in 2008, but have anybody make since this time new findings!
With Enterasys Switches I had no problems in the past to setup an LAG configuration.
IntroductionHow to use the Wireless LAN Controller Configuration Analyzer (WLCCA)
Javier Contreras is a Senior Tech Lead for the Wireless Business Unit in Cisco, with over 2 decades of experi...
< PRE >
(#)For this reason being that : - application that doesn't use multicast, sends one copy of each packet ( data unit of traffic at layer 3 ) to each client (" who seeks the traffic ).- application that does use multicast, sends ...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...